DID Rebuildable Atomizer

[Skullman]

Hey Vapor Dudes & Dudettes: I’ve been looking at the DID Rebuildable Atomizer I think it’s a Pretty Decent Looking Atomizer! It can be had both with a See Through tank or all Stainless tank I Like its Looks either way! I also like that they are using Stainless Steel Mesh for the Wick!

I’ve seen em listed with different names attached to em like DUD Chi Griffin with prices all over the place! So who’s familiar with them? What’s your opinion? Do they Leak? What are you using for Voltage Supply? Are you using Variable Voltage / Wattage? What are your settings? Hey & the all Stainless will work with those Volatile eLiquids!

Thanks
Skullman {:{}

 

[Joseph0280]

Hey Vapor Dudes & Dudettes: I’ve been looking at the DID Rebuildable Atomizer I think it’s a Pretty Decent Looking Atomizer! It can be had both with a See Through Tank or all Stainless Tank I Like its Looks either way! I also like that they are using Stainless Steel Mesh for the Wick!

I’ve seen em listed with different names attached to em like DUD Chi Griffin with prices all over the place! So who’s familiar with them? What’s your opinion? Do they Leak? What are you using for Voltage Supply? Are you using Variable Voltage / Wattage? What are your settings? Hey & the all Stainless will work with those Volatile eLiquids!

hey there,

If you're starting to learn how to use genesis RBA's. HAVE A LOT OF PATIENCE. It will pay off at the end.
I am very familiar with the DID genesis type atomizer. I've started learning genesis style RBA with DID & AGA-S. My opinion on DID is that is it very affordable. It's a good start for vapers wanting to learn how genesis style atomizers work. The flavor is very good! TONS of vapor if you get it to work correctly.

Your question about leaking. Yes, they all leak. They will ALL LEAK when tipped over. There is just no way they won't leak not unless you seal all the holes, but then again, the whole where the mesh goes into will have some sort of opening in the surrounding area still.

I used my did with my provari. Because when I was new I wasn't getting a consistent ohms whenever I wrap the mesh.
I have mine setup usually around 1.3-1.6ohms, using 3.6-3.8voltage.

Let me know if you have anymore questions regarding this atomizer. Also, go on youtube for extra opinions/reviews before you buy.

 

[Brenyo]

Hello!
If you want to use a genesis, I think you should go with the AGA-T2 (or T+). With 0,2 kanthal 4/3 (1.6ohm) its really awesome, especially on a provari at 3.6-4.0V

+1 Joseph