Morning fellow vapers. Just had a go at making my first coil making jig. It's a bit basic but does the job. I'm working on another one that allows me to change the allen key I'm using to wrap the wire around as at the moment it's fixed at 2mm.
DIY Coil Jig
- Thread starter Arkwright
- Start date
- th_trl_thread_readers 0
- Status
Morning fellow vapers. Just had a go at making my first coil making jig. It's a bit basic but does the job. I'm working on another one that allows me to change the allen key I'm using to wrap the wire around as at the moment it's fixed at 2mm.
I like that a lot. Simple but extremely efficient (just like me lol). I might have a go at that later on
Just an idea. If you want to make one to interchange your allen wrenches, drill bits, ect Just drill the same size hole to fit the size needed up the side then you can simply slide your tools in and out as you wish. Quick and easy. Personally I like your idea. I just wrap my coils free hand with a whatever size tool I need at the time.
I like that a lot. Thanks for posting. I was tempted to buy the one I have seen people using on here but this would do me just fine.
Took me about ten minutes to make and works like a dream. Been knocking out coils all afternoon, far more than I'll need for the next few months but it worked so well I couldn't stop myself.
Sent from my XT1032 using Tapatalk
Sent from my XT1032 using Tapatalk
- Status
Similar threads
