Dna 30 Or sx350 in vamo

[OthatGuy]

Has anyone tried it, is it possible? I'm not sure of the dimensions of the dna but I'm thinking that it just might fit. I happen to have a couple extra vamos laying around to try it, I'm looking to buy a cheap dna30 board if anyone has one pm me please. . .

I want to eventually run a 40 in a vamo for my dad, or any other tube, as he's accustomed to tubes and doesn't like the box form factor. Thanks

 

[BobC]

Can't do it

 

[mightymen]

Have you seen this VAMO 35 Variable Wattage mod - $46.98 How is this different than the 35W E-Holly???: FastTech Forums

I believe it has the sx300 chip in it - step up but not step down.

Just do ohms law and you'll vape at the same wattage all the time

4volts x 4volts = 16/ 2ohms = 8 watts all the time.

 

[OthatGuy]

Thanks guys just checking, the reason I wanted to do it was actually for a dna 40 my dad always burns his wicks n just keeps on vaping I'm trying to put a stop to that. Thanks for the info guys!

 

[mightymen]

Thanks guys just checking, the reason I wanted to do it was actually for a dna 40 my dad always burns his wicks n just keeps on vaping I'm trying to put a stop to that. Thanks for the info guys!

In that case IMO: it's not going to help by stepping up into higher wattage devices. The problem is he's getting dry hits and the wick burns.

About four months ago I switched from pro tanks to dual coil fogger and haven't once had a burnt wick, though I do go through more juice now. Just a better all around experience with dual coils and the right tank.

 

[OthatGuy]

Yup I'm a huge fan of the fogger v4. I have him running a Fv4 on the vamo then I have him my ProVari, the prob isn't talky that he's burning wicks is that he only barely knows how to put juice in the thing and I rebuild it whenever I see him but sometimes he's run 150+ml's thru it and the wicks, rayon, are hammered, I think if I step him up to a dna 40 with temp control I might get more milage or of it, but who knows I have one on order. I'm putting it in a bottom feeder, and I'll see how the temp control works out. I knew he doesn't like the shape of a box but I think if I set him up with a dna 40 feeder he won't be able to complain....

 

[DrBeaker]

I ripped apart a vamo and tried to slip the sx-350 board. No go screen is just a wee bit too wide.

 

[asdaq]

The SX board is quite a bit larger. The dna is still made to fit in a 3/4" round space albeit if you snap off the rails on the 40. The first video with brandon from evolv presenting the 20 has it in an acrylic tube with nails for the buttons.


Sent from my iPad using Tapatalk