Doc Dave micro mini atomizer

[Thugjustice]

Before anyone says anything, I know. I knew all about the tiny size of the deck and the tiny air holes and the tiny wick holes and the cramped space to work with. I know. My question is this. Has anyone had success with a silica setup? I tried using 1.5mm ekowool and it didn't wick worth a damn. I assume its cause the wick was just too tight.

And using mesh is tough because im usibg GVC juice and to me it taster way better ran through silica.

Any suggestiobs woukd be great.

Thinking of just boring out obe of the wick holes to make it work with 1.5 better. Idk yet.

 

[st0nedpenguin]

You'd probably have more luck buying an atty designed to run silica than trying to shoehorn silica into a genny.

 

[Cifitzu]

Well if anyone wants to sell or trade I really want a mini micro

 

[arth_d]

Make that 2

Well if anyone wants to sell or trade I really want a mini micro

 

[Krog]

I know this thread is a little old but I was hoping someone could tell me the size of the wick hole on the micro mini. I've got one on the way that I wanna put some SS cable in and need to know what size to order, width and length would be great! Thanks

 

[Dready]

I know this thread is a little old but I was hoping someone could tell me the size of the wick hole on the micro mini. I've got one on the way that I wanna put some SS cable in and need to know what size to order, width and length would be great! Thanks

What you want is 7x19 strand 1/16" 316 SS rope for the Mini Micro.