Does the ipv3li 200w update change the ohm limit ranges for temp. Control or power mode?

[famousnate187]

Wondering after you do the firmware update for the ipv3li 165 tc and update it to 200w does the ohm minimum and maximum change at all specifically for temp ni200 coils builds and/or power mode with kanthal anything else about the update or the device would also help

Thanks ahead of time! [emoji2]

Sent from my HTCONE using Tapatalk

 

[dangaranga]

im not saying yes or no, but mine was firing a .045ohm dual 26awg ni200 build no problem

 

[famousnate187]

After update?

Sent from my HTCONE using Tapatalk

 

[dangaranga]

Yessir. The ramp time and everything was good on it, I'd imagine it might be limiting itself because the resistance is so low