Im not used to the three posts, the post holes are huge, all my builds end up real messy caused by the screws on the posts they make my builds go out of wack when tightening
Im not used to the three posts, the post holes are huge, all my builds end up real messy caused by the screws on the posts they make my builds go out of wack when tightening
Yeah I experienced a fair bit of this with the doge V2. My screws would clip my wires pretty often, as a result, it's not my favorite atty to build on.
My fix was to just use more wire = harder for the posts to clip/mess with the wires. You can try not tightening them down fully until everything's sort of "in place", and then sort of fight against the tension with a screwdriver as you tighten down the posts. That's sort of the only way around it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.