Dotmod rta not reading

Status
Not open for further replies.

Eggwhite6

Full Member
Dec 30, 2016
5
4
27
So I just picked up a 24mm rta from dotmod, and I can't get it to read on my ohm meter or mod. I've also tried both pins that came with it. I'm not really sure what the problem is or what else I can do. Is anybody able to help me out?

Edit: When I put the rta on the ohm meter without coils, the ohms seem to bounce randomly and stop. with coils on it I can't seem to get a reading at all.
 
Last edited:

vapdivrr

Vaping Master
ECF Veteran
Verified Member
Jul 8, 2012
9,966
19,932
61
sarasota,fl
Is the actual tank all singed down correctly? I'm not familiar with that rta, but in some, if the base is not completely tightened to the deck, the 510 screw may not be making good contact. Just seems like it has something to do with the 510 screw.

Sent from my SCH-I545 using Tapatalk
 
  • Like
Reactions: Kprthevapr

Oomee

Super Member
ECF Veteran
Aug 6, 2013
534
1,830
UK
Multimeter on Ohms.
Measure the centre pin of 510 to internal terminal of atty.
Measure outside of 510 to internal ground pin of atty.

Both should return close to zero Ohms (same reading as when you touch the probes together).

If you find one of them is high, then the fault is along that path.
If both return zero, then you are looking at the connection between mod and atty.
 
Status
Not open for further replies.

Users who are viewing this thread