- Status
Mornin' clan,
quite a few of us drip around here.
There are numerous threads on filling cartos, including a video on how to fill one if you are blind.
Just root around a little and you will find some good info.
quite a few of us drip around here.
There are numerous threads on filling cartos, including a video on how to fill one if you are blind.
Just root around a little and you will find some good info.
When trying juices out I don't want to waste a carto so I use an inexpensive atomizer. I buy them here DSE-901 Atomizers 510, atomizer, e-cig, electronic cigarette [DSE-901 Atomizer] - $4.99 : ValueVapor.com, Discount Electronic Cigarettes and e-Liquid If I like the flavor then I will fill a carto and keep dripping from a small bottle throughout the day to keep it wet.
i have been filling the carts i just wanted to know if there was a way to drip with the cart so i didnt have to buy anything else
if i use the one you gave me the link to does it fit right on to the auto maxfusion batts and doi have to take off the atomizer each time i drip i heard the auto batts are not sealed
thanks
You don't want to drip directly into the carto if you are using a MF auto battery. There is a hole in the end and you will most likely trash the batt.
However, if using the new BMF manual batt, (very slick batt) you won't have a problem. The little white plug on the end acts a natural drip tip. Also Leaford is in the process of developing a new drip tip also for the MF cartos.
However, if using the new BMF manual batt, (very slick batt) you won't have a problem. The little white plug on the end acts a natural drip tip. Also Leaford is in the process of developing a new drip tip also for the MF cartos.
If you don't want to buy anything there is a way to drip but please note I DO NOT RECOMMEND IT as well as YOU MAY KILL YOUR BATTERY!!!
Take out the filling of your carto gently then put 1-2 drops of juice into your empty carto, be triple sure everything is dry on the atty end and then connect it to your bloog. Again if you take out the filling what you end up having is a crappy atty (crappy because it's not suppose to be an atty). Also as said before this way you can try out a lot of juice but if you use a auto bat BE SURE THE ATTY END STAYS DRY!!!
Might as well buy a atyy as blbutterfly said before you kill your $15 battery
Take out the filling of your carto gently then put 1-2 drops of juice into your empty carto, be triple sure everything is dry on the atty end and then connect it to your bloog. Again if you take out the filling what you end up having is a crappy atty (crappy because it's not suppose to be an atty). Also as said before this way you can try out a lot of juice but if you use a auto bat BE SURE THE ATTY END STAYS DRY!!!
Might as well buy a atyy as blbutterfly said before you kill your $15 battery
thanks that is what i wanted to know i really cant buy anything right now a lot of bills due lol i wll make sure i dry it out
thanks
if you have a manual battery please use that one because juice can almost not reach into the battery. If you do this with a auto bat you almost ask for trouble it is possible but it is also very very very risky. Best of luck Clam
If you want to drip I would suggest you get a bloog manual battery and a 901 atomizer.
thanks everyone is there a big differance between cartos and dripping
My BMF Dripper Carto: I wanted something that would taste the same as a loaded BMF carto (and attys dont!)
Remove filler from a good carto...clean filler material and dry by squeezing between paper towel.
Clean carto out w/ good hot water, blow out dry.
Cut poly filler sheet in half long way...cut those in half the short way...you now have 4 rectangle pieces.
Roll a piece into a 'rope'...doesnt have to be super tight/narrow. Start feeding the rope into carto around center tube.
Use a tooth pick to feed all the way around. Make sure it goes all the way around..if not,take out & pull/stretch it a little as you roll it and re-feed it in.
Use a drinking straw to push your filler ring down to bottom (dont pack it, just set it on bottom)
Drip 3 drops around carto between center tube and wall...let is soak into your ring a bit on the first fill...VAPE & ENJOY!
Performs/tastes exactly like a filled carto will!
Notes:
*Filler ring wicks juice like a full carto and keeps dripper carto from leaking, but it still will if you overfill...depends on liquid but 3 drops works great for most of my juices and I spread the drops around
*To change flavors: use a pick to gently pull out ring, clean out any residual juice by squeezing ring in layers of Ptowel, put back in and on to the next flavor! Super easy and takes a matter of seconds.
***I still recommend like the others that a sealed batt is used...if not, I would recommend dripping juice in with the carto off and checking bottom for leaks before putting it on the batt and vaping!!
Remove filler from a good carto...clean filler material and dry by squeezing between paper towel.
Clean carto out w/ good hot water, blow out dry.
Cut poly filler sheet in half long way...cut those in half the short way...you now have 4 rectangle pieces.
Roll a piece into a 'rope'...doesnt have to be super tight/narrow. Start feeding the rope into carto around center tube.
Use a tooth pick to feed all the way around. Make sure it goes all the way around..if not,take out & pull/stretch it a little as you roll it and re-feed it in.
Use a drinking straw to push your filler ring down to bottom (dont pack it, just set it on bottom)
Drip 3 drops around carto between center tube and wall...let is soak into your ring a bit on the first fill...VAPE & ENJOY!
Performs/tastes exactly like a filled carto will!
Notes:
*Filler ring wicks juice like a full carto and keeps dripper carto from leaking, but it still will if you overfill...depends on liquid but 3 drops works great for most of my juices and I spread the drops around
*To change flavors: use a pick to gently pull out ring, clean out any residual juice by squeezing ring in layers of Ptowel, put back in and on to the next flavor! Super easy and takes a matter of seconds.
***I still recommend like the others that a sealed batt is used...if not, I would recommend dripping juice in with the carto off and checking bottom for leaks before putting it on the batt and vaping!!
Last edited:
- Status
