Drip tip wont stay on

[rook2pawn]

ive been vaping for a week or two with my silver bullet and the drip tip (delrin) really wont stay down even if i push in the rubber o-ring the grip isnt just that good.

I'm now using scotch tape and it works, but that seems pretty poor. Does anyone have any recommendations for something better?

 

[Bimbo]

it's not locking? I've experience the same. I forced it by placing the top of the tip on a flat surface and pushed it really hard with the atty screwed to my ego. after a couple of puffs, the atty seems to soften the rubber and now it's ok.

 

[Mr.Self_Destruct]

are you using it on an atty or a carto?

 

[rook2pawn]

Im using it on a 510 atty.

 

[rook2pawn]

it's not locking? I've experience the same. I forced it by placing the top of the tip on a flat surface and pushed it really hard with the atty screwed to my ego. after a couple of puffs, the atty seems to soften the rubber and now it's ok.

Yeah, i was earlier trying to push the drip tip hard into the atty, but then i realized this just doesnt seem right for long term use. Im using scotch tape which may actually work out.

 

[richs10]

The problem may be the diameter of the atty. I have a low res stainless steel atomizer that must be just slightly bigger than normal. None of my cartridges or drip tips fit securely into it. Real PITA. The atty was a "freebie" with an eGo kit from a well known supplier. I think I know why it was a freebie.....

 

[tweazee]

You can get new o-rings at your hardware store.

Super T link has the size listed.
http://www.e-cigarette-forum.com/forum/super-t-manufacturing/

 

[tweazee]

PM forcedfuel50 -- it will be faster than searching the tread.
This is their website Electronic Cigarettes and AW batteries by Super T