Dripper help

[Superneat]

Hey guys,

I have a new Igo-L RBA and I'm loving it. I used the included wick and wire to make my coil. I'm happy enough with it.
So my question is this, at the moment I've vaped all the juice in it and I want to change the juice I'm using, how do I go about this?

Is it a case of taking the Igo-L apart, washing and/or soaking, or do I just add my new juice on top of the old stuff?

If I need to redo the coil with a new wick and wire, what should I be ordering?

Sorry for the noob questions, thanks!

 

[MattBott]

If the flavors are close enough together, you can just drip on top of the old flavor. You'll get a combination for a little bit, but if you stick to like groups (fruits, tobaccos, desserts, etc) its not that bad.

To completely get rid of the old flavor, and also clean off the coils, just take it apart, run it under some tap water, give it a rough dry with some paper towels and then "dry burn" it until I get all of my coils glowing again. You may get that "fresh coil taste" for a little bit, but once the coils start to build some "gunk" on them, that goes away.



If you want / need to replace the wick and coil, I'd suggest SilicaWicks.com Grab some 32 gauge Kanthal and some 3mm wick.

 

[Superneat]

Great stuff!!

Is awg the gauge of the wire?
Is this the right stuff here?
0.20mm Kanthal A1 Atomizer Resistance Wire x 5m | eBay

And is this wick ok?
3mm silica wick 100%, high quality, better than fibreglass wick, for atomizer | eBay