dripping and using 510 cart

Status
Not open for further replies.

SheerLuckHolmes

Ultra Member
ECF Veteran
Verified Member
Jul 28, 2009
1,354
562
74
Tempe, Az
With the SB is using the cart on the 510 a good experience or is dripping the best way to use the SB? I read a number of posts saying that the Prodigy melts carts left and right, which is why they say dripping is best.

But I want a nice big device like the SB while driving and want to use a cart for the long drives 'tween work and home.

Thanks
 

cddz

Supplier's Manufacturer - Offline
ECF Veteran
May 14, 2009
1,761
97
Newark, Ohio
With the SB is using the cart on the 510 a good experience or is dripping the best way to use the SB? I read a number of posts saying that the Prodigy melts carts left and right, which is why they say dripping is best.

But I want a nice big device like the SB while driving and want to use a cart for the long drives 'tween work and home.

Thanks
I think there is a bad batch of carts on the market.
Keep in mind when dripping the SB, if the atty floods to keep the top cleaned off. It will run down the side if the SB and get on the switch and get your fingers all yucky. I am not adding a channel or moat around the connector. Something about brass sitting in a pool of nicjuice sounds bad to me.
 
Last edited:

mamu

Ultra Member
ECF Veteran
Verified Member
Mar 29, 2009
2,551
1,523
IN USA
I am not adding a channel or moat around the connector.

That's good Chad. I really like the SB design as it is.

A simple swipe with a tissue takes care of excess liquid.

I have a couple of PVs that have the well and I don't care for it. It's a pain in the .... to clean the liquid out of those wells.

When the liquid collects in that well it changes the draw and I don't care for that either. Then you have to spend time putzing with getting the liquid out of the well rather than enjoying the vape.
 
Status
Not open for further replies.

Users who are viewing this thread