Dripping on bridgeless atties

Status
Not open for further replies.

DoubleHelix

Super Member
ECF Veteran
Verified Member
Aug 29, 2011
439
224
New Jersey
i was kind of turned off from buying atties from the classifieds section here on ECF after I got a batch of 510s I was just not pleased with for dripping or use with carts, was just going to stick with buying them new from a vendor, but then I also had purchased some bridgless 510 atties (not sure of resistance) from npmillertime, and WOW, In my Humble Opinion, a good bridgeless atties makes dripping much better. I am not techy enough to know why, but they perform great! Since I do not use atties with carts anymore, for straight dripping I am sticking with atties sans bridges from here on out.

did not mean to use this forum as a pump of for the seller, he got my positive feedback in the classies.
 
Last edited:

tj99959

ECF Guru
ECF Veteran
  • Aug 13, 2011
    15,114
    39,583
    utah
    how do you de-bridge a 510?

    Here ya go.

    Atomizer Debridge | De-bridge (HOW TO) - YouTube

    Note:
    I do not remove the metal mesh. I just push it off to the side, remove the bridge, and then tamp the mesh down along the sides of the coil cup.

    Looks like this when finished
    P1000460.jpg

    (wonders if I should clean that thing)
     
    Last edited:
    Status
    Not open for further replies.

    Users who are viewing this thread