Dual 3100 mAh DNA

[BJ43]

This is getting to be my favorite. Have tested it to 19 hours of vaping and it still was not discharged. The size and feel in hand is the best of all my PVs. It stands vertical without falling over easily. The belt sleeve is handy to carry when out in the wilds, hunting or fishing.
On board charging makes it complete and easy. Ended up using a long stem 10k pot from madvapes. Can't wait until I can get the 20w dna with meter in this box. The site posted has the box without the sleeve, I will have to keep searching to find were I got with a sleeve.

1pc 18650 Battery Case 2 x Parallel Connection DIY Case | eBay

 

[breaktru]

Nice build BJ. Good one

 

[BJ43]

Box with sleeve:
1pcs 18650 Battery Case 2 Parallel Connection DIY Case with 1 Canvas Bag | eBay

 

[Cjax]

what batteries are those? 2 in parallel makes 6200mah. you must be getting some real nice run times with that!

 

[BJ43]

what batteries are those? 2 in parallel makes 6200mah. you must be getting some real nice run times with that!

Two Protected Panasonic 18650 3100mAh Li ion Battery Cells Orbtronic 3100 PCB | eBay

So far I have only tested it to 19hrs.

 

[Skyway]

Nice. I used the same pot from Madvapes. It was OK'd by Dimension and it was easier than going to some other site where you needed a minimum quantity.
I have been curious about using an AW IC 18650 3100mAh battery in a DNA.

 

[venkman]

Nice looking mod. I've got one of mamu's Denali's, which uses the same case. For a dual 18650 box, it is surprisingly comfortable in the hand.

that's the same pot i'm using in the DNA mod i'm building. glad to know they play well together. I dremeled part of the stem off to fit a nice knob on there just about flush to the case.

 

[BJ43]

Nice looking mod. I've got one of mamu's Denali's, which uses the same case. For a dual 18650 box, it is surprisingly comfortable in the hand.

that's the same pot i'm using in the DNA mod i'm building. glad to know they play well together. I dremeled part of the stem off to fit a nice knob on there just about flush to the case.

I dremeled the shaft so it sticks out about a 1/4 inch, it has a flat side and works great, saw no need for an additional knob. Since this is my all day fishing mod, I didn't want anything that could break off with rough handling.

 

[venkman]

I dremeled the shaft so it sticks out about a 1/4 inch, it has a flat side and works great, saw no need for an additional knob. Since this is my all day fishing mod, I didn't want anything that could break off with rough handling.

I hear ya, i've had knobs pop off a few VV mods i have. My favorite adjustment knob is easily the one that mamu used on the minxy. it is so low profile that there is no chance of it snagging, catching, or popping off.

 

[BJ43]

I hear ya, i've had knobs pop off a few VV mods i have. My favorite adjustment knob is easily the one that mamu used on the minxy. it is so low profile that there is no chance of it snagging, catching, or popping off.

You have a link to it?

 

[venkman]

some good pictures are here

i think the specs are on the first page of the thread