Dumb brunette would love some tips on filling a DCT...

[Feuille]

So, hello, I am a bit of a ditz and could use some advice. Am sure the information is posted here somewhere, but I don't have access to a computer or a decent internet connection.

Got a dual coil tank atomiser this morning from the lovely Vulcan Vapes, and it works great, but I can't figure out how to fill the tank part without making a mess and losing lots of liquid. Am familiar with filling the central part with the filler, as I was using Boge cartomisers previously, but need some tips on the best way to fill the DCT.

Many thanks.

Xxx

 

[beebopnjazz]

Lower the carto below the top seals - enough space to get your bottle tip in a tad - hold the tank at an angle - start to fill. As the tank is filling slowly right the tank - once the juice is filling it follows the stream. Once you're near the top of the carto - stop. Carefully slide the carto into the top - making sure its seated well. If your carto is flanged check that the bottom is flush with the tank - or recessed into the bottom depending in your tank.

 

[Feuille]

Thanks a million bebopnjazz, you're a star.

Xx

 

[six]

There is a nifty tool for pushing the carto down so it doesn't go too far. The slap yo momma adapter from big daddy vaper works slick.

 

[Feuille]

My pinkie finger does the trick perfectly.

Xx