The 510 cartridges are not completely round on the bottom (bottom being the part inserted into the atty).
I went from a two piece (Greensmoke) to a Screwdriver that I got used with the 510 adapter. I had some 901 attys and carts.
My question concerns lining up the flats with the atomizer. Could not find anything online, but perhaps I did not look properly.
Is there a particular way to line up the carts to the atomizer? It would seem that the most logical way would be to line the flats at 90 degrees to the bridge (arch), but I could be wrong.
It could make no difference; also you could line them up along the axis of the bridge (arch).
Your inputs would be appreciated.
Tony
I went from a two piece (Greensmoke) to a Screwdriver that I got used with the 510 adapter. I had some 901 attys and carts.
My question concerns lining up the flats with the atomizer. Could not find anything online, but perhaps I did not look properly.
Is there a particular way to line up the carts to the atomizer? It would seem that the most logical way would be to line the flats at 90 degrees to the bridge (arch), but I could be wrong.
It could make no difference; also you could line them up along the axis of the bridge (arch).
Your inputs would be appreciated.
Tony