E-LVT burns up heat coils quickly

Status
Not open for further replies.

mattocs

New Member
Jun 28, 2014
2
0
Pittsburgh
I bought a E-LVT mod. With the mod, I bought an Atmos bulb. So, after a few tries, the coil stopped. So, I bought two spare coils. This time I ensured the voltage and wattage were on the lowest settings. Again, after a few tries, it died. I tried a third one. Again, same thing. Dead. I pressed the + & - at the same time and that confirmed it was dead with an error code.

Any ideas? I really want to use the device, but there is something going on.
 

SupplyDaddy

I'm considered a Mad Scientist in some circles!
ECF Veteran
Verified Member
Oct 21, 2012
3,365
5,010
62
San Antonio, Texas
What were the ohm ratings of the coils?
You can set either volts or set wattage, you can't set both, the setting you selected would help also.

Something else to check, is that you may have inadvertently pushed the E-LVT's center pin down, see if you can raise it up slightly using a small screwdriver, paper clip or toothpick. (This is one of the most common reasons for a "dead" coil.. it may be just not touching the contacts..)
 

Baditude

ECF Guru
ECF Veteran
Apr 8, 2012
30,394
73,077
71
Ridgeway, Ohio
Your battery device (E-LVT) is fine, but you have chosen what I believe is the wrong juice attachment for it.

From what I can tell, the Atmos bulb is for wax concentrates only, NOT e-liquids. Atmos Bulb Under forum rules, I can't spell out what this device is marketed for.

Try any clearomizer or clearotank juice attachment for your E-LVT. Clearomizers will have replacement coil heads ($3.00) which you can replace when they go bad, usually every 10 - 20 days or when the flavor begins to taste burnt. From the looks of it, the LVT will accept both eGo (female) and 510 (male) connections. There are many clearomizers to choose from.

Proper Terminology: Is It a Carto, a Tank, or What?

Vapers Table: Delivery Systems

If I may, I recommend the Kanger Evod clearomizer for your LVT. Kanger Evod 2
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread