Ego C Question

[Beel Weelson]

Hi all,

So I have had an Ego C for about 6 days now, completely analog free and I love it. One problem. Today after bringing it with me to work when I went to use it, there was juice all on the inside of the clear plastic tank, in areas that it normally doesnt flow into (around the part where i put my mouth on)

why is this? Broken tank?

My 2nd question is should i upgrade to a clearomizer and will this one work for an ego c Vision Ego Clearomizer V2.0

thank in advance!

 

[MadKat]

Hi Beel W...I'mma friend
Yes to the ego vision clearomizer or a Kanger M-T3 is a good choice

 

[Beel Weelson]

Hi friend

The kanger is a little bulky for my liking, do you know if the leaking inside of the stock tank is because it is just a cheap and flimsy tank?

 

[Kent C]

Hi friend

The kanger is a little bulky for my liking, do you know if the leaking inside of the stock tank is because it is just a cheap and flimsy tank?

I believe the only difference between the T3 and MT3 is the cosmetic metal skin - there's still a poly tank inside and the knurled part is a little wider to accomodate the metal skin - bit different color metal too. So it's a bit bigger and heavier.

One does get condensation on the outside of the eGo-c tank - completely normal. And the eGo-c tank is less likely to crack than a vision stardust, even with the corrosive flavors - menthol, cinnamon, 'atomics' FYI, after a long successful time with the eGo-c system, I've switched over to the T3's for easier fill, less maintenance, more volume and imo, more flavor and vapor.

 

[MadKat]

ahhh! I have found that most things will leak or gurgle a bit, the kangers do this when the liquid gets low but I've had few problems with either of the 2 I mentioned. Condensation is a good bet, as Kent C said.

 

[yotasavg]

I had leaking issues on original ego C tanks too, I don't think you will be dissapointed by a T3 or an MT3. I have both and I love them equally, possibly the MT3 more. But if you're worried about size (I am) look into the mini T3's. They use the same head but the tank part is smaller, by a little less than half. I already wish I would have gotten one since it takes me about a full work week to get through a full T3 (I'm a very light vaper).

 

[chimsweep]

I have got 2 of the MT3's in the mail along with 1...that's one....or single..or the ONLY one UDCT tank with one Dual Coil carto...

 

[chimsweep]

As for the leaking........someone else I know had a major leak at DD(work)...Get some light flow out the tank....I find the leaking gets less and less with time.

 

[Killowatt]

Does it look like little droplets? That's condensation as stated above, normal. Heated moisture cooling down. I'm new as well, but read this here.

 

[SupplyDaddy]

If your juice (not condensation) is going up into the tank to the mouth piece, it means you need to reduce your suction a bit. You're drawing on it a touch harder than that little tank can take. Too much flow. Alternately, you may not have the tank seated fully into the cone, or, the tank cap sitting on the atomizer has a bad seal around the atomizer spike.
For any of those, simple pull the tank off and blow the excess out (preferably onto a tissue or napkin so you're not spraying it everywhere..), reseat the tank and continue vaping!

There are several alternatives to the C tanks. Cartos, Clearos, different tanks. Most will also work on the eGo-C batteries you have. (510/eGo connection)

 

[p-doze]

another vote for condensation. fwiw, when mine started doing that, i made the jump to clearomizers and haven't looked back.