eGo T Atomizer PROBLEM

[roblectric]

Bought two new atomizers for my eGo tank. The spike that pierces the tank was much larger than my original atomizer. Both were supposed to be Joye tanks. I forced one of them on thinking "ok, tighter fit equals less leakage" but when I went to refill, the cap for the tank remained on the spike.
Any suggestions would be appreciated.

 

[SkeetS]

You have 2 types of eGo-T attys. They are type A and type B.
Type A are cones and type B are cylinders.
Check if the one you had are the same to those you had.

On the cap of the tank you can remove them by using a set of tweezers and if it's hard to come out, boil the atty (so the plastic cap heats BUT TRY NO TO MELT IT) and then use the tweezers to remove it.

 

[roblectric]

Type A atty. Spike is much bigger. Waiting for response from vendor. Hole in tank was prepunched from first atty spike.