eGo-T tght draw

[Astronomer]

Newbie here

I have an eGo-T with 2 batteries ( a 3rd in the mail ) and 3 attys ( ordered an extra )

One of my attys has a particularly tight draw, I know it is the atty as if I move the same tank, and battery to one of the other Attys the draw is not as tight. ( and yes I line the grooves on the tank up with the spaces on the atty cover with the puncture device. )

Is there an easy way to adjust this? Suspect it is those little grooves on the battery side of the atty?

It is true that this is the one atty that I have not done my deep cleaning routine on yet

 

[ledouxmike]

Have you tried to blow it out? I have one that's doing this too. I put it aside for now. Let me know what you find out.

 

[Astronomer]

Oh yes... I did all that, but I just read the thread below about hitting the button for a full second before taking a hit... I am going to try that too

( I still think there is a difference in the vent groves on the edge of the atty )

 

[g3p]

The method I found worked well is here

 

[Astronomer]

I read that after I posted... and am trying that now with my good atty... I like it ( hitting the button for a second before drawing the first time )

I will try that when I get home with the other atty.... thank you!

 

[g3p]

Glad to help

 

[OldDragon]

Was having a little problem with getting enough vap out, one of the threads had a link to a site that showed that the wick is in the hole puncher and that the wick could be moved a little bit. Moved mine up a hair and now it works like a champ.

 

[ledouxmike]

I heard someone say that the wick being too low in the tube can also cause dry hits. I guess that was the cause in your case also.

 

[Twisty]

One thing to be aware of is where the air slots are on the atty. Depending on how I am holding it sometimes I cover that slot with my thumb causing a tight draw.

Harry

 

[ksmith]

Was having a little problem with getting enough vap out, one of the threads had a link to a site that showed that the wick is in the hole puncher and that the wick could be moved a little bit. Moved mine up a hair and now it works like a champ.

I have seen how to move it down a bit, but how do you move it up?

 

[OldDragon]

I used a needle point to move mine up a little, seemed to help. All so can remove the 2nd piece of plastic in the tip of the tank, helps a little in the air flow.

 

[swedishfish]

Was having a little problem with getting enough vap out, one of the threads had a link to a site that showed that the wick is in the hole puncher and that the wick could be moved a little bit. Moved mine up a hair and now it works like a champ.

Do you happen to have a link to that?