Ego threaded RDA

[suspectK]

I've been on the search for a rba for my aurora. Anyone know of any good ego threaded bottom feeding RBAs, or rda that can be easily modded to do it. To me, it sounds like I'm searching for a phoenix...

Thanks

 

[Spacedoutart]

I can recommend 2 different ones I have used. The Optimus RDA from madvapes and the phoenix RDA (aka the Bulli) The Optimus is easier to work with and best works with a vertical coil. They both use a 510 connection and you can use a "ego beauty ring" to cover the ego threads and make it a little more sturdy. Both of these RDA are the same diameter as the ego. Hope this helps a little.
Optimus coil:
Phoenix coil:

 

[Jazzi Mike]

I don't think the above suggestions are bottom feeding.

My experiences with bottom feeding RDAs are only with my Reo, but so far the Reomizer 2.0 is the best RDA for bottom feeding. The Vicious Ant Cyclone is nice too, but you have to specify to get a bottom fed version. The A7 also works as a bottom feeder. It has some issues with the Reo, but it might work on the Aurora.

 

[Spacedoutart]

ah... missed that bottom feed part

 

[suspectK]

I'm trying to find an ego threaded RDA. I have an AGI, and it won't make contact in the 510 connection. So I'm not really wanting to find that out the hard way with just getting a 510 contact. If the adapter I had would make contact, I would just go that route, but that doesn't make contact either...

 

[Spacedoutart]

Sound like you may need to carefully raise the center post inside the 510 connection. Use a small flathead screw driver or a paperclip and slowly raise the center post upwards. Move around it so it lifts evenly. And be careful as you can lift it too much and pull of the gasket behind it that holds it down

 

[spaceman84]

Pretty sure there are ego to 510 adapters you could use.

Sent from my HTC6435LVW using Tapatalk

 

[Izan]

Era inspired. The base/body appear to be SS (got in a trade).
Drill center post from bottom (I used a .8mm bit) and at deck level. ****Clear Debris***
510-510 shorty unsealed adapter, a generic slim ego plinth and few o-rings and bobs your uncle.
(Blind squonk modification needed if you haven't done it already. )

Have fun
I