Ego Twist only firing when evod isn't connected all of the way?

Status
Not open for further replies.

mygul

Full Member
Mar 19, 2013
11
0
Louisiana
I bought a kanger evod and an ego twist two weeks ago and everything was working fine until last night when I went to charge it and it wouldn't connect. I read about the center pin issue so I pulled it up a little at a time until it showed a connection. It charged all night like everything was fine but now it won't fire unless I barely have it screwed on?

The light comes on but nothing happens unless it's loosely attached to the base. Any help would be awesome
 

Forkeh

Super Member
ECF Veteran
Verified Member
Feb 16, 2012
910
660
California
You may have mashed the connection back down again when you screwed it on the charger. It's not hard to do. And I don't know if it's my imagination or anything, but I've found that once you mash down a connection plate on a battery and have to pull it up, it's infinitely easier to do again; it gets mashed down easier. Maybe that's my imagination? I don't know. But I feel like that's the case. Only screw it on tight enough to make a connection, no more. Try pulling it up again, but carefully!

If that doesn't work, check out your tank. What sort of coil do you have in it? Do you have the original Evod coil set up? Or do you have the Pro-Tank set up? The Pro-Tank has a removable head that screws into the base; it's replaceable. The original is all one unit. If you've got the Pro-Tank coils, you may not have the head screwed in all the way. They can come loose over time. Every time I refill mine, I check the head to make sure it's in tight. Try that.

If all else fails, you may just have a squirrly head. Maybe one of the connection wires came loose? Maybe it's dying on you? They don't last forever. Try replacing it.
 
Status
Not open for further replies.

Users who are viewing this thread