eleaf istick 50W

Status
Not open for further replies.

TXBiker

Super Member
ECF Veteran
Verified Member
Aug 27, 2014
529
418
Center of Texas
I don't think it has a problem firing a single coil. It did o.k. with my orchid when I built at .6 26ga 3mm duals but read it at .8 so voltages were a little off. When I went below .5 my usa meter read the build at .39 the problems started. It started shutting off and I got a short light show a day after trying the build. It developed the misfire a month after I got it then the jumping between volts and watts. It never had a problem with clearo's kanger ST's or aspire atlantis. It still won't read my rebuildables without freaking about ohms and getting the voltages wrong. I've got a .8 dual coil on my orchid and a .5 on my goblin that the vapor shark sees fine but put in the istick and it's all over the map.
 

Baditude

ECF Guru
ECF Veteran
Apr 8, 2012
30,394
73,077
72
Ridgeway, Ohio

TXBiker

Super Member
ECF Veteran
Verified Member
Aug 27, 2014
529
418
Center of Texas
I won't do it Bad I can't say something is good when I had a lot of the issues happen to me. This thing isn't what ismoka claimed it would be and they will not back up their product. I stopped using mine before it got dangerous. Ismoka just put 4 pretty new finishes on the 30w and my wife wants one. I'm just not sure,these cheap mods bit me one too many times. She has my VS 30w and loves it, she just wants something pretty to carry. Tried to get her to pick a jwrap or a different colored shark skin, but who know with that woman lol. I spent $154 for 2 mods the 30w for her and the rDNA 40 for me. The final mod I ordered today was an IPV 4 for $65 and I'm officially done. I have a back up board for the rDNA new in the box and I wanted to try the YIHI and liked the dual 18650's everything else is a bonus.
 
Status
Not open for further replies.

Users who are viewing this thread