Elevator dna20 problems

[tom_87]

Hye...would like to seek some help here as my elevator did not function as it should...i cant increase or decrease the watt on it...it just stays at 7watt...really appreciate if someone could help

Sent from my GT-I9105P using Tapatalk

 

[benda]

your down button must be stuck or you have a ground issue on the board on the pot location. i had the same issue with mine, sent my board back to evolve, Brandon told me a spec of solder was in the pot hookup location on the board so the board things a pot is hooked up to it, or like i said the down button could be bad and stuck

 

[BulletStopper]

I do not have a dna 20 mod, but have read about them and watched many reviews.

Phil Busardo specifically mentions this in his review of the DNA 20.

He also talks about how that isn't valid because the voltage step down circuit isn't that effective and shows how it will only decrease the voltage approximately 0.3 volts. That means that with a low ohm setup the DNA 20 pushes whatever the actual battery voltage is.