EVic VTC Mini newbie help burning smell

[djsvapour]

Yes 1.1% is 11mg/ml which is what I said. I mean I don't know what the ratio of pg/vg so I assume it's even.

So you did, I understand what you meant now. I don't think in grams, only ml. (my fault)..

I'm calling it a day too now. Good luck.

 

[luke maher]

Thanks to the two of you for your help im putting in a new coil now I'll let you know how it goes. Cheers!

 

[jacob bonilla]

only 3 factors should really play a roll 1. ONLY use temp mode for Ni and Ti coils NOTHING ELSE, ONLY USE wattage mode for kanthal coils 2. are you using the correct temps? too high of a temp will burn your cotton 3. not sure on this one but did you lock the settings? i have the evic vt never used temp mode so i wouldn't know but wattage mode i know you dont need to lock settings.

if using pre built coils chances are your going to need to use a lower temp because i find that pre built coils tend to suck as far as wicking goes can barely run them at 25watts for the most part without it getting charred versus my rda and rta i can run at 25 at the lowest and go up to 50's

 

[luke maher]

I updated it and switched to a titanium coil now it seems to be not burny at all but temp protection isn't letting me know for sure

 

[jacob bonilla]

why? wat does ur temp read?