Evic vtc mini
- Thread starter Kenneth68
- Start date
- th_trl_thread_readers 0
- Status
what coil are you using and at what power level or temp control?
The Tron comes with the 1Ω head installed, it uses the ego one CL replacement heads.
It includes one .4Ω Ti & one .2Ω Ni head, these are for use in temp control mode only.
Use the 1Ω head in power mode/watts, use the others in the appropriate temp control mode Ni / Ti.
The resistance should be printed on the side of the head. Or small air hole through the center = 1Ω, large air hole = sub ohm resistance.
The head must be thoroughly primed before use or the wicking material will burn/scorch, after being burnt it must be replaced. It will never wick properly & most likley give a burnt harsh taste.
Prime the head by dripping drops of liquid on top of screen in head until wicking material is fully saturated, then install in base, fill tank, thread together, take a few unpowered primer puffs.
Start off at a low power setting & slowly work your way up taking a vape or three on each setting until you find what you like.
What is the Pg/Vg ratio & nic mg/ml of the juice you are you using?
It includes one .4Ω Ti & one .2Ω Ni head, these are for use in temp control mode only.
Use the 1Ω head in power mode/watts, use the others in the appropriate temp control mode Ni / Ti.
The resistance should be printed on the side of the head. Or small air hole through the center = 1Ω, large air hole = sub ohm resistance.
The head must be thoroughly primed before use or the wicking material will burn/scorch, after being burnt it must be replaced. It will never wick properly & most likley give a burnt harsh taste.
Prime the head by dripping drops of liquid on top of screen in head until wicking material is fully saturated, then install in base, fill tank, thread together, take a few unpowered primer puffs.
Start off at a low power setting & slowly work your way up taking a vape or three on each setting until you find what you like.
What is the Pg/Vg ratio & nic mg/ml of the juice you are you using?
Thank you so much for your help its working perfectly now hope to GOD THIS WILL HELP ME QUIT THIS HABIT
Hi Kenneth ive been using evic mini for past 3 months and swear by it as all info above follow that with ni a ti coils and you wont go wrong
- Status
Similar threads
