FastTech JM Clone Review

[dmazyn]

Well I got my JM Full tube set clone from fasttech yesterday so thought I would do a quick review for anyone looking at this clone.

First off it looks very nice and clean with a nice presentation box. I quickly put the 18350 tube together and found out right off the bat that a nipple top battery did not allow everything to fit without gaps. I took the top off and noticed the brass nut is to large to run nipple tops correctly. I took off the nut and just left the center pin and was able to have no gaps.

Next I put on my RSST for a first Vape, pushed the button and found the button to be way to easy to fire. Trying to set the mod down standing up will fire every time even without an atty on top. I took apart the button and found the below wimpy spring (See picture below). So getting past the weak spring the mod kicked my RSST into life with a great vape running at 1 ohm.

I love the size of this mod compared to other mods I own. In 18350 mode it is smaller than my Natural and magneto even using a 18490 this mod is the same height of a 18350 natural/magneto.

Pictures:

Presentation:

18350 mode compared to 18350 Natural/Magneto:

18490 mode compared to 18350 Natural/Magneto:

Wimpy Spring:

 

[retired1]

Moved to E-Cigarette APV Reviews

 

[dmazyn]

After 24 hour use the mod is still running good. One thing I noticed is the if you have the button threaded tight it does not always make contact with the bottom of the battery. It was an easy fix I just put a small piece of tissue to shorten the button threaded hole and now it fires every time.