Favorite porta/pocket/stealth setup?

[snickers]

The Provari and agat2 has become my go to rig. I guess you can say I'm a convert into the rba world now. I love the vape I'm getting so far but am wondering what are some pocket suggestions? Yes this will fit, but not without some heft and risk of leaking on me.

Anyone have an rba that is indestructible in the pocket? I have a couple twists and the carto tank option is ok, but I'm specifically looking for an RBA that can hold 2-3mls. Suggestions? Personal favorites?

 

[cricque]

ego-c twist + mini vivi nova is my favorite, its just so damn handy and small

mini did perhaps ?

 

[Rule62]

A Short DID on a Natural, in 18350 mode is pretty small; but not indestructable. It has a pyrex tank.

 

[iKN0WaGH0ST]

Using a REO mini with an era right now. I actually got the setup today and it is outstanding when set up with mesh! 1.3 ohm coil. Plenty of vapor, warmth, and flavor. It is fantastic.

Sent from my Galaxy Nexus using Tapatalk 2

 

[chadster214]

Vapage V-Mod 2.0 is a compact pocketable bottom feeder.. smaller than a pack of cigarette.

 

[snickers]

A Short DID on a Natural, in 18350 mode is pretty small; but not indestructable. It has a pyrex tank.

The Natural is very appealing to me. Clean, sounds like good reviews, and the price is right. I'm not sure why I'm opposed to the looks of square type mods? Just am.

I know nothing is really indestructible but basically I mean isn't fragile and leaky if tipped on side or even upside down for a brief bit. Where can one pick up one of these short DIDs you mention? I see lots of reviews but not many links to US vendors.

 

[super_X_drifter]

I'm running a REO grand and chalice V1 with a supershort Delrin drip tip. Very pocket friendly setup.

 

[scrappy]

I'm using a natural in 18350 mode and an Igo-l with ss mesh. Drip 3-4 drops in there then vape it till it's gone and you won't have any leaking issues.

 

[MJBinNM]

Where can one pick up one of these short DIDs you mention? I see lots of reviews but not many links to US vendors.

MMVapors (Greece) is the only place to get the Short DID.

I use a Super-T P+18350 with a SS Mini DID clone from Sure Vapes with a Pyrex tank from IBTanked with a short SS drip tip. I find it to be very pocket friendly and don't have leaking issues (I wouldn't leave it upside down or on its side too long). I do leave the fill screw in and don't have wicking problems. I roll my wick so it fits kinda loose in the wick hole which seems to allow enough air into the tank.

 

[beanpusher]

kts in 18350 with an rda...even with 2 bored out airholes to 3/32 and 10 drops on pure 100% cotton dual coiled and no leaks here. sits on the kts quite nice

 

[aPandaz]

This is my current daily set up - Mortar V5 in 18350 mode with IGO-L, 0.8 ohm coil on silica. Very compact and pocket friendly. It won't hold 2-3 mL, more like 10 drops...but I don't chain vape so it's not a problem for me. No problem with leaking and lots of flavor, vapor, and nice throat hit.

 

[CountSmackula]

I use an MVP with a Chobra on top.
Fill screw in. Wick hole full of wick.
No runs, no drips, no errors.

 

[c00lkatz]

KTS with a shortened solid brass negative post, Small Terminator sitting on top.

 

[PhreakySTS9]

I'm going to say, you guessed it, a Penelope! Check the classies for one, the ultimate out and about tank RBA!

 

[snickers]

KTS with a shortened solid brass negative post, Small Terminator sitting on top.

I'm thinking K100 with a small terminator on top. Is the small Terminator strictly for dripping or can it hold a little liquid?

 

[TheSneakerHoarder]

Poldiac 18350+Odysseus Drip mode.

Nary an issue. Sub an Igo-L for the Ody.

(That is, if you are into rebuildables and SLR coils.

 

[Chuckq4yoo]

The GP paps or Gus in 18350 mode or a dingo. So freaken tiny!

 

[c00lkatz]

I'm thinking K100 with a small terminator on top. Is the small Terminator strictly for dripping or can it hold a little liquid?

It's not bad, but I think it looks a little goofy. The K100 is much wider and really dwarfs the small Terminator in comparison. As for height, it's the same as the KTS without even needing to mod and even with the bottom button, so that's a plus.

As for the mini Terminator itself, it's dripping only. It doesn't hold a lot. Even with the wicks turned up inside the top cap rather than down in the channels, I don't get more than 4-6 drops on a refill and at low resistance (1-1.2 ohm) that lasts me maybe 10 6-7 second puffs (or toots some say lol) at most. It's definitely a nice RDA and as for quality, it's worth the money. But if you don't want to drip a lot then don't get it.

For out and about all day use at work I actually use a Natural v2 with a Terminator-C. The capacity of the Terminator-C along with an MNKE lasts me all day no problem, just fill and go. If you want to match, the Natural and Terminator are the same finish and look really nice together, especially when you properly set the center pin height. The Natural is also much easier to mod than the KTS to get less voltage drop. Dropping in a solid brass center post was MUCH easier on the Natural than it was the KTS, but the KTS switch will be much easier to mod too, so 6 of one, half dozen of the other. I actually got less voltage drop out of the box on the K100 than either the KTS or Natural, but with some modding, the Natural does the best with the KTS coming in second (all tested using the same atty and coil setup). The Natural is the tallest out of the 3. But now I'm rambling, so I'll stop lol.

 

[xsphat]

Just picked up one of these: Sigelei EA clone. That will be my stealth setup with my Igo-L on top.

Or the VMOD XL, who can ever tell.

 

[c00lkatz]

Just picked up one of these: Sigelei EA clone. That will be my stealth setup with my Igo-L on top.

Or the VMOD XL, who can ever tell.

I didn't see that.