Finally got a Mech and RDA today

Status
Not open for further replies.

scottkh

Full Member
Sep 12, 2014
43
32
Birmingham Al
After months of reading and research I finally purchased a CLT Atty and Stingray X and i was not disappointed. Holy crap at the vape experience i have been missing. The flavor and the total vape has just been ratched up for me 10 fold. I get it now plus I am a mechanic so the very nature of RDAs appeal to me. I was always left wanting using my nautilus and Naut Mini iclears etc....used a couple different vv/vw mods but now i feel like i have hit the golden standard.
Talk to you guys later before i start rambling, hit a little to much got a nic buzz!
 
I had the same experience a few months back. The only vv mod I have left is an itaste svd that I've been using to test resistances or do a quick battery level check. I plan on getting a standalone ohm meter and a passthrough voltage tester but in the meantime it works for me. Usually I make 1.0ohm coils and run single in a kayfun or dual parallel for a .5ohm or quad parrallel for 2.5ohm in a dripper. Since the svd does not read below .6, I use this mini optimus rda with 2 posts and thumb screws as my mount for coil metering and test each coil individually before mounting to something else.
 
Status
Not open for further replies.

Users who are viewing this thread