Firing Nautilus off a nemesis?

[SouthBay]

My evic died on me and I don't have any other VV or VW mods. Would it be safe to use an aspire nautilus on a nemesis?

The batteries I have are:

Samsung ICR 18650 (10 amps continuous)

Efest IMR 18650 (35 amps continuous)

Would this be too much for the nautilus? I hope it's not a daft question, I mean I'm still learning about ohms and coils etc.

 

[State O' Flux]

The battery isn't too relevant... as the lowest resistance amp draw for a nautilus head is still well below the current output of even a second rate 18350.
It would however be in your best interests to use a Kick in an unregulated mech when using production type glassomizers... as a level of wattage control would better suit the OE coil head, for best flavor, longevity, performance and control.

 

[kathi17]

My evic died on me and I don't have any other VV or VW mods. Would it be safe to use an aspire nautilus on a nemesis?

The batteries I have are:

Samsung ICR 18650 (10 amps continuous)

Efest IMR 18650 (35 amps continuous)

Would this be too much for the nautilus? I hope it's not a daft question, I mean I'm still learning about ohms and coils etc.

I sometimes use my Nautilus on my Nemesis. I think what you have to worry about are sub ohms.

 

[lamebore]

Are you using stock coils that came with the nautilus? What is the ohm reading on them? The only thing I owuld worry about is a short, which is unlikely but can happen.

 

[Jscheiben]

Just got a nemesis today and have been using my nautilus on it at times.