Firing Problems
- Thread starter BonelessWizard
- Start date
- th_trl_thread_readers 0
- Status
Have you considered turning it off before you screw on the atty, and then turning it back on? 
When one of my mods screwed up it would fire on and off - So while waiting for another mod i would screw the atty on and off to vape.
so something is wrong - bad chip , sticking fire button. Im not familiar with the lunar.
so something is wrong - bad chip , sticking fire button. Im not familiar with the lunar.
I believe the Lunar is a mechanical, hence my suggestion. Whenever I put an atty on my mechs I unscrew the bottom a bit, so the battery can't make contact.
Last edited:
It worked fine before with the tugboat. I might need to get a new spring for the button. It gets stuck every once in a while but not too often
I just screw the atty off a little and fire it with the button and it works alright. I'll probably check with a shop
Does your mod have an adjustable contact? Not all attys are created equal and I have one that I can't use on my Gus. It the opposite problem than you have, since the RTA pushes the contact down and it won't fire. Afterwards, the mod won't fire anything until I take it apart and pull the pin up.
Yeah it has an adjustable contact. I took it all apart and messed around to see any problems. No luck so far
Do you know if it fires when the atty touches the pin on the mod or when it touches the metal around it ?
Something is making it fire once it has a connection - , my dodgy one would go on and off as i screwed the atty onto it.
No fix though - just ordered another different mod.
Something is making it fire once it has a connection - , my dodgy one would go on and off as i screwed the atty onto it.
No fix though - just ordered another different mod.
- Status
Similar threads
- Locked
