I got all my parts in the mail and I'll be building a dual 18650 box mod tonight. I got the schematic and understand everything. I also have a plume veil rba and 28g kanthal and a 1/8th drill bit to wrap it on. What coil should I build for a lot of vaper? I was recommended to build a single 1.0ohm coil?
First box mod build advice
- Thread starter aceroc
- Start date
- th_trl_thread_readers 0
- Status
If your going with an unregulated dual 18 at 4.2 not stacked. I like my plume at 0.4 running 2 1/8th at 5 wraps 26 kanthal. If you are making a raptor type build slight hight and use higher volts. Adjust to desired likeness.
Just to clarify, you've never vaped a rebuildable before, and you're starting by building your own unregulated dual box mod?
Not saying it's a bad idea, just didnt know that was a thing.
Not saying it's a bad idea, just didnt know that was a thing.
If you are new to rebuildables a 1.0 ohm single coil is a good place to start.
How low you should build will ultimately depend on the CDR of your batteries. So if you are not familiar with battery safety, Ohm's Law, amp limitations. etc. I highly recommend you let us know so we can post some links to resources for you.
How low you should build will ultimately depend on the CDR of your batteries. So if you are not familiar with battery safety, Ohm's Law, amp limitations. etc. I highly recommend you let us know so we can post some links to resources for you.
Will this box be regulated or unregulated? are you wiring the batteries in series or parallel? make well and sure that you don't exceed the limitations of your batteries, building a box mod is serious business, and can be very dangerous. a 1.0 ohm single coil would be a place to start i suppose.. be careful and make sure you get high quality batteries.
- Status
Similar threads
- Locked
