First dual Ti build on my Goliath.

[Matty316]

I've had my Goliath for a while now but have always struggled to get a consistent vape using kanthal with it. My vaping style is I'll chain vape for around 10 mins then not touch my setup for around an hour. With kanthal I always seemed to start getting dry hits after about 5 or 6 pulls then have to wait for the wick to catch up. I thought about using a TC build in it before but all my TC mods only supported Ni200.

I recently got my IPV4s so decided to try a dual Ti build in it. I made up a dual 26 gauge 6 wrap build coming in at .14 ohms, set to 30 joules and 400F.
When I fired it up it was an absolute revelation. It was so consistent, pull after pull as good as the last. I have to say I'm completely sold on Ti temp control it has allowed me to start using an atty again that I had all but given up hope on.

 

[Cheker]

It's a great tank I use it with dual ti but make sure you don't use to much cotton to wick or else it won't wick correctly what with the juice having to go through a slot and a thin bit of tank!