First mech mod need advice

[Danielboon]

I am getting a sentinel clone I believe it is a m16?? Is that a good mech mod for a newbie upgrading from a evod starter kit??

 

[Mark in Florida]

You'll get about a million different opinions on that one, and some will just be ethical and moral stances on clones. But, yeah... It's a telescopic which is good. I've seen at least one review on that clone (rip trippers) that seems to indicate it's as good as the authentic. Another good one along the same lines would be the titan cronus clone.Telescopic, very low voltage drop...

 

[Susan~S]

If you are new to mech mods have you read up on battery safety, ohms law and amp draw? What type of atomizer/tank are you going to be using on your mech mod? I have many links I can provide if I know where you are in your vaping journey.

 

[Danielboon]

Afew months in to vapeing been using the evod starter kit. I want to go to rdas making coils and what not. I will be using a 18650 2100 mah 30 amp batterie. Will maybe only get a couple mechs I will be getting more into dna 30's 15,50 watt box mods but for ....s and giggles I would like to have a few mechs and a guy is gifting me one of his mechs the sentinel lol. That's were I is.

 

[Danielboon]

I figure if I build a .5 and higher I should be ok right.

 

[FallenRawToast]

advice... buy a multimeter, learn ohms law, understand that your 30amp battery may not really be 30amps....

 

[dice57]

Afew months in to vapeing been using the evod starter kit. I want to go to rdas making coils and what not. I will be using a 18650 2100 mah 30 amp batterie. Will maybe only get a couple mechs I will be getting more into dna 30's 15,50 watt box mods but for ....s and giggles I would like to have a few mechs and a guy is gifting me one of his mechs the sentinel lol. That's were I is.

I figure if I build a .5 and higher I should be ok right.

hmm, looks like the batts are good, VTC4's??? but truthfully, feel it's best to learn to build on a regulated, then venture into mechs. much safer. but yeah, assuming you have the correct batts, 0.5 ohms and higher will be no problem, provided there is no shorts and the build is competent. Ohm meter is a must have.

 

[Bwood91]

Best advice I can give is learn all parts in and out know the difference between a low battery and when it's not firing right