First mod: RM2 air flow control

[Verb]

I drilled out and added and airflow control collar to my reomizer 2.
i used an off the shelf 1/2 inch copper pipe coupler. Squished slightly to an ellipse, it fits and functions well. Using a crimp type tube cutter without reaming one side keeps the collar from falling off the top.

 

[classwife]

Creative !

 

[super_X_drifter]

I drilled out and added and airflow control collar to my reomizer 2.
i used an off the shelf 1/2 inch copper pipe coupler. Squished slightly to an ellipse, it fits and functions well. Using a crimp type tube cutter without reaming one side keeps the collar from falling off the top.

That looks beast. Nice work bro

 

[Verb]

Thank you. It continues to work well. I also hit the sweet spot with coil position on the RM2. Quite the flavor factory.

 

[cloudsfordaze]

is there a reason it is off center?

 

[Verb]

If I understand your question correctly:
The collar is turned to cover the air hole. Top pic the air hole is centered and fully open. The others show the collar turned to reduce the flow.

It you mean the top-down pic, the ring was slightly ovaled because the off the shelf pipe stock was a hair to large. Giving it a little squish enabled a higher seal on the air hole and less prone to rotating on its own.

 

[Norrin]

Looks good and if it's working even better