first plume veil build, thoughts? suggestions?

Status
Not open for further replies.

dwarfcat

Super Member
ECF Veteran
Aug 15, 2013
716
824
41
Grand Rapids MI
Couldn't resist picking up an ehpro plume veil today. I built it very much like Ive been building my tugboat. The vape at 30w seems to be nice and airy and not too hot but I wanted to see if you plume veil pros saw anything inherently wrong with my build. thanks


2zibt3r.png


jtl1fm.png


2m3h07a.png
 

DaveSignal

Ultra Member
ECF Veteran
Verified Member
Aug 23, 2014
1,878
1,578
44
Maryland
Too much cotton for my builds. I like to leave airflow from the negative posts and plenty in front and under the coils. But I do less wraps (6/5 wraps of 24 gauge) to drop down to about .21 ohm. My mech mods put out around 85 watts for this build.

I am surprised that those coils even heat up in reasonable amount of time at 30 watts.
 

dwarfcat

Super Member
ECF Veteran
Aug 15, 2013
716
824
41
Grand Rapids MI
Too much cotton for my builds. I like to leave airflow from the negative posts and plenty in front and under the coils. But I do less wraps (6/5 wraps of 24 gauge) to drop down to about .21 ohm. My mech mods put out around 85 watts for this build.

I am surprised that those coils even heat up in reasonable amount of time at 30 watts.


My coils are 10 wrap 26g coils. The build comes out to .6ohms and the vapor is instant at 30.6w. I do think ill experiment with a bit less cotton, so far it seems pretty good but I wouldnt do more and im curious what less vapes like
 
Status
Not open for further replies.

Users who are viewing this thread