First Stillare RDA what's a good coil?
- Thread starter Mattfox27
- Start date
- th_trl_thread_readers 0
- Status
Are you looking for flavor or clouds? Or both?
On my Stillare, I usually build with 24 gauge, a dual coil (parallel) build with 8 wraps on a 3/32" wrapping post. It usually comes in at 0.32Ω or so. If you have not built sub-ohm builds before then please do not try this build. If this is the case, I would recommend a much higher resistance.
The thing is, builds are such a personal preference thing. It may be that every build we tell you, you won't like. Use this site to play around and see what you like! Coil wrapping | Steam Engine | free vaping calculators
On my Stillare, I usually build with 24 gauge, a dual coil (parallel) build with 8 wraps on a 3/32" wrapping post. It usually comes in at 0.32Ω or so. If you have not built sub-ohm builds before then please do not try this build. If this is the case, I would recommend a much higher resistance.
The thing is, builds are such a personal preference thing. It may be that every build we tell you, you won't like. Use this site to play around and see what you like! Coil wrapping | Steam Engine | free vaping calculators
IMO parallels are the way to go, I do dual parallel coils with 5 wraps with 26g kanthal. You get the surface area of basically 10 wraps per coil for flavor, but half the resistance, so it gets good and warm for vapor production. As mentioned above, just be safe. Parallels can be a little bit tricky to wrap until you get the hang of it.
There's some good tutorials in YouTube, if you can wrap a decent regular coil you shouldn't have too much trouble.
- Status
Similar threads
- Locked
