need advise for coil
- Thread starter shamilrz
- Start date
- th_trl_thread_readers 0
- Status
With three posts so your ohms are cut in half if you use all posts, I can tell you that you probably will have to sub Ohm with 24 guage coil.
I dont care for sub ohming myself.
The coil build greatly depends on what what your ohms are, or what ohms you want. That is what you need to look at first. since you have a dripper that I think can manage only two posts and a single build, you should probably get a little higher guage coil and try a ohm level a little higher to start.
But it is your choice.
I dont care for sub ohming myself.
The coil build greatly depends on what what your ohms are, or what ohms you want. That is what you need to look at first. since you have a dripper that I think can manage only two posts and a single build, you should probably get a little higher guage coil and try a ohm level a little higher to start.
But it is your choice.
Last edited:
I use 26g, dual coils 4 to 5 wraps around a precision screwdriver, and get between .2 and .3 ohms. Fires fast, warm vapor, and great flavor
yeah..the problem with my build is when low on battery, it fires slow...
The wire you are using is bigger, which means more surface area to heat. Use a little smaller wire, and you'll get better results. There's a lot of tinkering Involved in coil building. I've found that 26g is perfect for me. You might want to have a few batteries to put in rotation if you want to stay that low sub ohming.
28g, on a 1/16 drill bit, 8 wrap dual coil. I am using it with cotton wick on the Stillare V2, getting VERY good results. Close off about 3/4 of the air slot, gives very flavorful and warm(not hot) vape, very satisfying setup. Using the Cartel Stillare V2 clone on a Nemesis clone, Sony VTC 4 batteries.
Best solution to this is... recharge your battery... with a mech you run the risk of over-discharge which can cause battery failure...
- Status
Similar threads
