First tank issues - flooding

Status
Not open for further replies.

elgatoenelsombrero

Senior Member
ECF Veteran
Verified Member
May 1, 2012
103
12
36
Gautier, MS
I just got my baby notta tank in the mail.. assembled it correctly with a prepunched boge 2.0ohm carto registering at 2.2 ohms and I'm using chocolate hazelnut tobacco 12 mg nic 80pg/20vg liquid. The first 5 or 6 tokes were fantastic... then constant flooding and juice in my mouth :( whats the problem here?

and let me just say, ECBlends chocolate hazelnut tobacco is DELICIOUS lol
 
Last edited:

njgeek

Super Member
ECF Veteran
Verified Member
Apr 9, 2012
339
289
Princeton
You should only need 1 hole for PG. Where is the hole inside the tank? It should be somewhat close to the bottom (connector), but not too far down. Did you prefill the carto too full when you slid it in the tank? Also, are you removing the top cap of the tank to fill it? Doing so lets in too much air. Instead, slide the carto down into the tank with drip tip on and tilt it while you fill, then slide the carto through the top o rings. Make sure the drip tip is on it so you don't tear up the o rings.

If you pop the whole cap off then back on, the pressure will tidal wave your carto and flood it.

Wipe off the connector, take off the drip tip, clench the connector between your front teeth, wrap your lips around the tank, and give it a. Good blast of air or two to clear liquid from the middle. Put the tip back on, screw in the tank, and take a couple sharp hits without pressing the button. Then try vaping again.
 
Status
Not open for further replies.

Users who are viewing this thread