Fixing/improving Taifun clone

[Commie]

Hi there!

So I have a Taifun GT clone, and love the vapor from it. One issue with it though. When I unscrew the tank, at the bottom as I'm supposed to, the chimney tube comes off the tank and stays on the atomizer chamber. Thus, dumps the leftover juice into my unsuspecting lap.

I can't really tell if the tube is supposed to screw into the top cap and my threads are stripped, or if it's press-fit.

I was thinking about crazy gluing it into the cap, or using some epoxy to keep it there.

Have any of you guys had the same issue? And would you recommend doing this, or something else?

Thanks!
Commie

 

[Phone Guy]

Mine do not come apart.

 

[Thrasher]

it is pressfit and is pretty much the only flaw with the clone. the real one is one solid piece.

dont really think i would use superglue but an epoxy used for plumbing may be ok. in general if its not safe to go in my mouth i wouldnt use it on an atty