Flat-top top button-top

Status
Not open for further replies.

3mg Meniere

Vaping Master
ECF Veteran
Verified Member
Mar 24, 2013
6,493
65,098
75
Tomah Wisconsin

dc99

Vaping Master
ECF Veteran
Verified Member
Aug 17, 2014
3,086
9,572
earth
They do work. Some of the nemi clones you have to remove that thin ring between the tube to make the battery fit properly. If not it has to much room. Some of the clones fit awesome and some are horrible. They all work better with the magnet upgrade though. FDV has an excellent upgrade kit for it. Or they did the last time I looked
 
  • Like
Reactions: 3mg Meniere

3mg Meniere

Vaping Master
ECF Veteran
Verified Member
Mar 24, 2013
6,493
65,098
75
Tomah Wisconsin
Removing the thin ring does not work well, makes the tube too short for flat-top, unless I unscrew the bottom-cap screw quite a way, to the point where I can see the spring, and the trigger gets stuck on the bottom edge. No need to get the magnets until I get the second nemmy, so I will order both at once.
 

Ryedan

ECF Guru
ECF Veteran
Verified Member
Mar 31, 2012
12,869
19,652
Ontario, Canada
Yeah, you have to expect to fiddle a bit with stuff from FT.

Circuit Board Spacer I had the solution sitting in my parts box all the time, and didn't even know it. It is sitting on top of the kick, and filling just the right amount of space.

Using a simple magnet at the positive end of the battery carries the risk that if the magnet moves to the side far enough to make contact with the inside of the mod you'll short the battery when you hit the button. I think the circuit board spacer eliminats that risk by keeping the metal in the spacer from making contact with the inside of the mod.
 
Status
Not open for further replies.

Users who are viewing this thread