Floating Resistance in Vision V3

[Paval]

Ive been using the Vision V3 clearo for about a month and a half now, and I am on the 3rd replacement head. Im using the Lambo 4.0.
The third head has been on now for oh, about a week now, and I installed a 3.0 ohm head. When I installed it, it measured 3.1 ohms on the Lambos resistance check. About 3 days later the resistance started to float up, to 3.3. No problems vaping, used about a 4.8 - 5.0 volt setting and good performance. Now a full week later its at 3.6 ohms? What causes it to float or change like that? Is this a sign of the coil getting gunked up? or is the coil starting to fail? Its still workin great. Thanks.

 

[madmach]

Check it with a ohm,s meter to see if you are getting a good true reading.

 

[Paval]

Check it with a ohm,s meter to see if you are getting a good true reading.

Thanks madmach, I checked it with my meter, and it reads 4.5 ohms, and I had 0.9 resistance between my probe leads. So subtracted from the 4.5 I equate a true 3.6 resistance. So both the device and meter confirm equal check of resistance. Just seems weird, was thinking of cleaning it real good, and see if it returns to what it originally was of 3.0-3.1