From what minimum ohms resistance Evic starts to read it?

[MrVP]

I'm doing my own resistances and all of them says "atomizer short" or "no atomizer found".
Can someone tell me?



Thanks and have a good day!

 

[dice57]

Need to be above 1 ohm, 1.5-2 ohms would serve better. Also depending on the atomizer, you may just not getting contact with the center pin. Get the same error whether there is nothing attached or a coil is built to low to register.

What atomizer, rba, rda, rta, do you have?? Are you building a coil? if so guage of wire being used would be good to know.


Vape long and Prosper.!!!

 

[MrVP]

Thanks for responding, first!

RDA, gauge 40.

I thought it would be the contact pin, but it can read others atomizers resistances. It reads my Nautilus resistance perfectlly. It reads the 2.1ohms iClear 30s.
It's just with the iTaste VF and my very own build resistances.
But nevermind.
There's a Kayfun Lite V2 Clone coming.
Me and this iTaste didn't match.

Thanks for your help!

 

[tj99959]

40ga wire doesn't compute! That wire would be so thin that you would never get a coil to hold up.
Don't forget that there is also a contact pin in the RDA, and it must touch the pin in your PV or you will get the "no atomizer found" message. You will also get that message if the coil "popped".

 

[Sthur]

Evic coils have to be above 1.2. I run 30 guage in my pro tank rebuilds and 28 in my KFL and work great on my EVic.

 

[Bwood91]

Try pushing down on the center post