Fuhattan question

[Chris Oglesby]

Hello all, i finally decided which mod I want. I chose the fuhattan. Does anyone know if a efest 2000 mah button top battery work with this mod? I have a bunch of these efest batteries so it would be nice to not have to buy different batteries. Thanks guys

 

[WharfRat1976]

It will work fine. I use efests in mine. The pin can be a little fussy. All you do is push it up into your atty then raise the button pin far enough to trap it all together with no battery rattle and you will be good to go.

Every now and then make sure to re-tighten your firing pin from your switch. As you depress the pin it tends to loosen as your switch button will turn a little every time you depress it causing the pin to unwind. It's a small PITA for an inexpensive mod that hits like a mule.

 

[Susan~S]

Depending on which Efest 2000 mAh battery you have they may only be 10A CDR.

BATTERIES

Battery Basics for Mods: IMR or Protected ICR?
* Another essential read to understand which batteries are safe to use in mechanical and regulated mods. Includes a frequently updated list of recommended safe-chemistry, high-drain batteries with their specifications.

Purple Efest Batteries not as Advertised
* A cautionary blog that reveals that the purple Efest batteries may not have the specifications advertised. Also includes a commentary on "continuous discharge ratings" vs "pulse discharge ratings" of battery specs.

 

[Chris Oglesby]

Would it be ok to buy my vaping supplies from amazon such as kanthol and cotton? Or where else is a vendor I can buy from? 26 gauge good for beginner? And for the cotton, I'm I looking for just 100% organic or do I need to look for something else. Thanks

 

[Topwater Elvis]

Hello all, i finally decided which mod I want. I chose the fuhattan. Does anyone know if a efest 2000 mah button top battery work with this mod? I have a bunch of these efest batteries so it would be nice to not have to buy different batteries. Thanks guys

The efest 2000mah 18650"s have a 7ish amp ~ 10a max CDR which will limit the resistance ranges of the coils you can safely use.

---> Test / Review: Efest IMR18650 2000mAh (red) | BudgetLightForum.com

 

[juggler86]

Would it be ok to buy my vaping supplies from amazon such as kanthol and cotton? Or where else is a vendor I can buy from? 26 gauge good for beginner? And for the cotton, I'm I looking for just 100% organic or do I need to look for something else. Thanks

Ya its fine. I buy all my wire off of eBay so dont see why amazon would be any different.

 

[WharfRat1976]

Would it be ok to buy my vaping supplies from amazon such as kanthol and cotton? Or where else is a vendor I can buy from? 26 gauge good for beginner? And for the cotton, I'm I looking for just 100% organic or do I need to look for something else. Thanks

As stated above yes that will work. You do not want to build a coil that will exceed the discharge of your battery regardless of what battery you will use. As stated above, using that battery you have a 10amp continuous discharge so you need a basic understanding of math and ohms law to not blow your face off.

Here is a good link to get you going with the basics: Battery Safety and Ohm's Law - onVaping

 

[RamShot Rowdy]

I'd suggest you read my blog Ohm's Law 101 For Vapers (Link in signature.), I give examples of using Ohm's Law to check battery safety. With a 10 amp CDR battery you do not want to go any lower than 0.5 ohms with your builds.