getting burnt out

[Suicidebob]

So, when I first started I had a DS-801. I've always had issues with that unit not producing enough vapor and delivering disgusting burnt taste. A few months after that I bought myself a Prodigy V3.1 I've had some dang good times with that unit- delivering decent vapr and taste. However, those goodtimes were always short. I've ran into bad times.. a lot. Producing not enough vapor or very little. Even on new atomizers. I bought 6 atomizers this past week and had tons of issues. I had one work perfectly for 2 days and then it starts to go down. I'll clean it in vodka for about 15 minutes, blow in it and let it sit and the next morning I'll use it and it won't produce some vapor but not a lot and it'll give me a horrible taste. Now, i'm stuck with the constant blowing out any juice and trying it again and not getting anything. These attys are 306's LR.

any thoughts?

 

[Rockproof]

Dual Coil Cartos got me off of subpar (mind you...name brand) 306 LR atty's. They are all that I use anymore. Have you tried any DCC's yet?

 

[Suicidebob]

I have one right infront of me and to be honest, that thing is giving me problems as well. I've filled it up and now popping sounds. I know it's not dry but I'm still messing with it as we speak.

 

[Iffy]

Those pops are 'happy farts' from a satisfied carto! vape it...

 

[Freddytk421]

I just started and bought a gas station ecig. the carts it came with didnt give me any smoke but I refilled it with pure glycerin because I wanted to play around while waiting for a shipment of the good stuff. This thing is billowing plumes of smoke like a dragon lives here. im not kidding I was going to quit vaping before I even started but once I saw that I was so excited I ordered lots of stuff. basicaly what im saying is I think glycerin based stuff is where the smoke is at. im a total noob though.

 

[Boodle]

My 2 cents: Take your LR306 off your mod, leave the DT on and blow into a tissue several times. Keep at it until you're not getting juice funk in your tissue. Put the atty back on your mod (fresh batt in your mod) remove the drip tip and drip 2 drops on either side of the upside down V, getting the juice down in the cup. Give it a slight blow to move the juice along if it's thick. Now you should have 4 drops in the cup under the bridge and wick. Put your DT on and take a primer pull then add one more drop down the DT with a blow to move the juice along. You should be set for a nice vape session.

Sometimes you have to blow them out and start over. It's the only thing that seems to work. I drip into attys LR 510s and 306s) almost exclusively. It's the best vape you can get but it can get frustrating when an atty gets finicky on you. Nice to have cartos around for those occassions. Good luck to you.