I've removed my feed tube from the nipple several times and always just pressed it back into place. I don't think its necessary, but I would like to glue it back just because I get paranoid that it will eventually just slip out easily. All of the 'super' glues I've looked at have some seriously scary warning hazards so I'm wondering what Rob uses to secure these, and if its something I can buy at my local hardware store.
Glue for feed tube?
- Thread starter hildicat
- Start date
- th_trl_thread_readers 0
- Status
I believe it's super glue...but not positive. I've never used any glue when replacing mine. However, I do suggest if you are going to ever use it that you put a small dot only on the nipple side before putting the tube on. Not in the tube side...that way you're not getting glue in the tube where it comes into contact with the juice. Never was told that....just my own weirdness about glue.
hot glue may workor what Lisa said but i never glue mine anymore. i like to take the tube off when cleaning sometimes
whatever you do....it only needs to be a very minute amount. It really doesn't take much.
I use a couple drops super glue at the very base of the brass nipple were it connects to the positive plate .None of the glue ever gets inside the feed lines .
- Status
