Golden Greek Cleaning out triple wick dual coil .8ohms - 1.0 ohms Penelope. 3.7V-7.4 Volts
Osiris11 asked in regards to my triple wick document the following question
"Bishopheals the flavor seems to be dying now after a good few days of intensive vaping, I can't taste it as much but still have smoke....
Would that be a wick issue or wire ???"
I made this video to help anyone wanting to know how to clean your ati and to reuse your coil and wick. Flavor goes after a few days of pumping some serious voltage on that coil and wick. After a cleaning its back the way it was. You can perform the same steps with your Odysseus.
like to add a minor correction. When I said before I had GGTS and I used Provari I was able to vape at single coil @ .8-..9 ohms highest bolts was 3.6 before E1 flashed. In video i said 1.5 so i wanted to correct that. Dual coils at that Ohm .8 is E1 nightmare.
Dry burn is strongly not recommended because you can damage the coils and other things. Not many folks are skilled to do it right. What I did was a wet burn while wick was soaked in hot water. No different how juice gets evaporated since wick is soaked and then evaporated by heating coils. This process wont damage the device as long you do it at low voltage and for small amount time like 5 seconds then off blow 3 times then repeat. I used standard voltage from GGTS 3.7 Volts. I would press fire button for 5 seconds and wait 3 seconds while I blow into the coil and repeat till i you see a 1-2 red coils. once you see a red coil you need to reduce from 5 seconds to 3 seconds do this 2-3 more times minimum. if you don't see all your coils red then replace and re do a new coil. If you do see all your coils lit then stop and examine wick. look to see if wick is white. If wick is still dirty repeat process with either hot boiled water in cup and dump the ceramic assembly into the cup or run it again with hot water gently. then repeat process. The moist wick with your ejucie and finish building your ati. and give it a test run on low voltage then gradually adjust to your sweet spot.
Any questions feel free to contact me.
If you plan to maximize voltage for GGTS which is 7.4 volts you will need to use the batteries the batteries I shown. It's very important to avoid any explosion or boom using this device with imitatio or bad batteries. I strognly advise getting a fuse that way your protected at all times.
Battery to use: Important you use AW IMR 18650 3.7 Volt 2000mAh which I purchased from Clouds of Vapor. I strongly recommend if you want to vape at 7.4 volts with different batteries or different ohms please check with me or Imeo on the ECF forums GG sections. That way we can let you know if its safe.
Please vape safe and responsibly
.
3 wick guide
http://www.e-cigarette-forum.com/forum/clouds-vapor/312600-triple-wick-coil.html
GGTS 3 upper tubes for 2 18650 batteries
Brass
http://www.cloudsofvapor.com/store/...r/1395-advance-order-ggts-brass-top-tube.html
or
Stainless Steel
http://www.cloudsofvapor.com/store/...r/1381-advance-order-ggts-steel-top-tube.html
Video
http://www.youtube.com/watch?v=VNeZGTTsGFw&list=UUOdpIge4fkLNgoPIgB7fwtw&index=2&feature=plpp_video
Osiris11 asked in regards to my triple wick document the following question
"Bishopheals the flavor seems to be dying now after a good few days of intensive vaping, I can't taste it as much but still have smoke....
Would that be a wick issue or wire ???"
I made this video to help anyone wanting to know how to clean your ati and to reuse your coil and wick. Flavor goes after a few days of pumping some serious voltage on that coil and wick. After a cleaning its back the way it was. You can perform the same steps with your Odysseus.
like to add a minor correction. When I said before I had GGTS and I used Provari I was able to vape at single coil @ .8-..9 ohms highest bolts was 3.6 before E1 flashed. In video i said 1.5 so i wanted to correct that. Dual coils at that Ohm .8 is E1 nightmare.
Dry burn is strongly not recommended because you can damage the coils and other things. Not many folks are skilled to do it right. What I did was a wet burn while wick was soaked in hot water. No different how juice gets evaporated since wick is soaked and then evaporated by heating coils. This process wont damage the device as long you do it at low voltage and for small amount time like 5 seconds then off blow 3 times then repeat. I used standard voltage from GGTS 3.7 Volts. I would press fire button for 5 seconds and wait 3 seconds while I blow into the coil and repeat till i you see a 1-2 red coils. once you see a red coil you need to reduce from 5 seconds to 3 seconds do this 2-3 more times minimum. if you don't see all your coils red then replace and re do a new coil. If you do see all your coils lit then stop and examine wick. look to see if wick is white. If wick is still dirty repeat process with either hot boiled water in cup and dump the ceramic assembly into the cup or run it again with hot water gently. then repeat process. The moist wick with your ejucie and finish building your ati. and give it a test run on low voltage then gradually adjust to your sweet spot.
Any questions feel free to contact me.
If you plan to maximize voltage for GGTS which is 7.4 volts you will need to use the batteries the batteries I shown. It's very important to avoid any explosion or boom using this device with imitatio or bad batteries. I strognly advise getting a fuse that way your protected at all times.
Battery to use: Important you use AW IMR 18650 3.7 Volt 2000mAh which I purchased from Clouds of Vapor. I strongly recommend if you want to vape at 7.4 volts with different batteries or different ohms please check with me or Imeo on the ECF forums GG sections. That way we can let you know if its safe.
Please vape safe and responsibly
.
3 wick guide
http://www.e-cigarette-forum.com/forum/clouds-vapor/312600-triple-wick-coil.html
GGTS 3 upper tubes for 2 18650 batteries
Brass
http://www.cloudsofvapor.com/store/...r/1395-advance-order-ggts-brass-top-tube.html
or
Stainless Steel
http://www.cloudsofvapor.com/store/...r/1381-advance-order-ggts-steel-top-tube.html
Video
http://www.youtube.com/watch?v=VNeZGTTsGFw&list=UUOdpIge4fkLNgoPIgB7fwtw&index=2&feature=plpp_video
Last edited:
mmmmmmmmm
