Got my Provari today!!! but...

Status
Not open for further replies.

TimmyB5286

Senior Member
ECF Veteran
Verified Member
Dec 13, 2011
98
50
Ohio
I was so excited to open that box from Provape and pull out my Provari! Unscrewing the battery tube was so smooth. I put in my battery, pressed a button to see the awesome blue led. I screwed on my UDCT, and I have no airflow!! :mad: I can unscrew it a little bit and get some airflow, but if it is fully screwed on, no airflow... I'm currently searching for my 510 to eGo connector to see if that will help, but I have no clue where that is. Anyone else encounter this?
 

jasl90

Ultra Member
ECF Veteran
Verified Member
Jan 30, 2012
1,688
1,754
Jacksonville, FL
I've never used a UDCT (or a DCT)... That said the outer collar of the Provari top cap is flush with the top of the 510 connector and has no air flow grooves cut into it.

Anything that pulls air from the connector and sits flush with the outer ring of the top cap is going to have problems unless the tank has air flow slots notched in the base.

You could probably use a Dremel tool to cut a couple of small grooves in the bottom of the tank to allow air flow.
 

Baditude

ECF Guru
ECF Veteran
Apr 8, 2012
30,394
73,076
71
Ridgeway, Ohio
Last edited:

TimmyB5286

Senior Member
ECF Veteran
Verified Member
Dec 13, 2011
98
50
Ohio
Thanks for the info! Guess I gotta make another order.. lol. I just found my iClear 30 and ordered that as I was waiting for the mailman to drop off my package... I tried my UDCT on it loosely, but don't like the wobble. Guess I'm stuck with my eVic still until I get that adapter..lol
adeline, how bad is the gap?
 
Status
Not open for further replies.

Users who are viewing this thread