I have a Hades clone and the switch keeps coming apart while using it. It just did it again and the magnets shattered. Takes two hands to operate with stiff springs always wanting the button to push at an angle. Anyone know where I can find magnets for it and maybe how to stop it from coming apart?
Hades magnets
- Thread starter Dumas Mesuri
- Start date
- th_trl_thread_readers 0
- Status
I have one coming. After reading all the flaws. I think I'm just going to find a thinner spring at the hardware store.
I was thinking more like teflon tape. Not sure how that would affect ground though. It seems to be holding fine with the spring, now if I could find my bionic pinky!
If you are already using bottom firing mechs, that spring probably won't bother you too much. I went from mvp2 to this so it's a bit awkward for me at this point.
be sure to check your vent holes, mine were cleaned up but not good enough. 30 seconds with a dremel might save a trip to the hospital.
A few plugged holes never scared me. Take a guess how many vent holes are on my authentic Cronus
Yes 0. Now that's a different story. Thanks for your help man.
No problem, thanks for helping jailbreak me
I just found a post saying nemesis magnets work. If someone could confirm that, I would let some take the slow boat from china.
These are more expensive but at least you won't have to wait forever bro. SHOP - FatDaddyVapes.com - Home of the best vaping equipment, eliquids, and supplies!!!
Anyone confirm the Nemesis magnets are the same size used in the Hades? I love ordering from fatdaddyvapes! Dennis is the man.
Thank you!
This big dummy forgot to order magnets with my last fasttech order. I did try the extra spring and so far so good, it is much lighter than the installed spring.
I finally received my Hades SS/ Brass today from fasttech. I removed the spring and the centerpin. Hits harder. It came with magnets but no spring.
Gratz man, still enjoying mine with the weaker spring. These things work without the centerpin and spring on top?
Thanks Dumas. Yeah man. The positive center pin and spring was not tight enough for a good connection. I completely removed it. I loosened the positive nut closest to the battery and then tighten the top cap with the atty already connected. Works much better for me.
- Status
Similar threads
- Locked
