Hades Mod Top Cap stuck,

[CloudChaserSchizo]

guys help. anyone got an idea to unstuck this 2? the one on top is the lower cap of cerberus rda and the one on the bottom is the hades top cap.

 

[DaveSignal]

try removing the pin in the 510 first. Then see if you can unscrew it by hand.

If that doesn't work, pliers.

 

[Jimi D.]

Put it in the freezer for awhile. That should loosen the bind.

 

[CloudChaserSchizo]

tried putting in the freezer and also tried using the pliers. still cant open it.

 

[rhelton]

did you remove the 510 like posted above. if you get them too hot they will vaccum seal, ive popped 510's out and had them pop from the release.

 

[TwistedThrottle]

Rubber bands. Fat ones. The threads will slice thru if too skinny but they should give ya the grip ya need.

 

[CloudChaserSchizo]

did you remove the 510 like posted above. if you get them too hot they will vaccum seal, ive popped 510's out and had them pop from the release.

the 510 is the thing in the bottom part right?

 

[rhelton]

yah the battery rattle adjusment pin take it out. It probably sealed from getting hot. then if wont come off put it in the freezer again with that part out.

 

[CloudChaserSchizo]

dealing with this for almost 7 hrs. so hard to unstuck this metal. tried freezing it for almost 2 hrs took it out and still it wont budge.

 

[eyerhere]

You could try ice on the inside one and heat on the outside one. Maybe expantion and contraction at the same time will give you wiggle room.
Now I gotta know how the heck did you do that?

 

[CloudChaserSchizo]

You could try ice on the inside one and heat on the outside one. Maybe expantion and contraction at the same time will give you wiggle room.
Now I gotta know how the heck did you do that?

ok ill try to do that. just going to put that metal piece on the freezer.

i really dont know what happen. just woke up this morning going to change my rda and that happen.

 

[CloudChaserSchizo]

You could try ice on the inside one and heat on the outside one. Maybe expantion and contraction at the same time will give you wiggle room.
Now I gotta know how the heck did you do that?

ok ill try to do that. just going to put that metal piece on the freezer.

i really dont know what happen. just woke up this morning going to change my rda and that happen.

 

[CloudChaserSchizo]

sorry for the double post. this thing is really stressing me out. LOL.

 

[CloudChaserSchizo]

after some few hours of sleep. finally got it out using expantion and contraction. thanks for the reply guys.