I have a hana dna 30, when I try to use my kayfun on it, it say check atomizer, when i put the kayfun on my mvp2 it reads it fine and fires, anyone know what the problem could be? Thanks
The Kayfun has an adjustable center pin, it might be recessed a little bit, so use a screwdriver to unscrew it just enough so it makes contact with the center pin of your Hana
The DNA 30 should be able to fire as low as .5 ohms. Its capabilities far exceed the mvp2...
I also have to second the adjustable center pin theory, it might not be making full contact with the Hana.
The DNA 30 should be able to fire as low as .5 ohms. Its capabilities far exceed the mvp2...
I also have to second the adjustable center pin theory, it might not be making full contact with the Hana.
Yeah, you just have to make sure you hold the block where you attach the positive lead to, because it might spin when you try adjusting the bottom post.
Yeah, you just have to make sure you hold the block where you attach the positive lead to, because it might spin when you try adjusting the bottom post.
The DNA 30 should be able to fire as low as .5 ohms. Its capabilities far exceed the mvp2...
I also have to second the adjustable center pin theory, it might not be making full contact with the Hana.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.